|
|
发表于 2007-6-5 14:26:42
|
显示全部楼层
Printer Status Error Message=>打印机LCD显示
The holder is at the replacement position. After replacing the print head or the ink tank, close the front cover of the printer. To replace only the ink tanks, do not remove the print head from the printer. Do not touch the locking lever.
喷头定位杆未拨回
The printer’s front cover is open. If printing is in progress, the print head or ink tank cannot be changed. Close the front cover, wait for printing to finish, then open the cover again and change the print head or ink tank.
前盖开启
Printer is busy.列印中
Printer is offline.列印机已离线
Paper out! Load paper and press printer’s RESUME button.缺纸
Paper jammed. Remove jammed paper and press printer’s RESUME button.卡纸
The remaining level of the following ink is unknown: There is a possibility that the printer cannot detect the remaining ink level properly. Reset the ink counter using the Maintenance tab of the printer driver whenever you have replaced any ink tank with new one.无法估计墨量
The waste ink absorber (the used ink tank) is full. Cancel printing and turn the printer off and then back on. If this doesn't clear the error, see the printer manual for more details. *1废墨将满
Service error. Cancel printing and turn the printer off and then back on. If this doesn't clear the error, see the printer manual for more detail.废墨全满
The printer’s front cover was opened after the last printing. If you have replaced an ink tank with a new one, reset the ink counter on the Maintenance tab of the printer driver.最终列印后前盖曾开启 重设墨量
Executing the processing specified by a digital camera
or another computer. 正由影像装置或网路电脑读取图像
Executing the processing specified by the operation panel, a digital camera, or another computer. 正由记忆卡或网路电脑读取图像
Printing is disabled since the printer's card slot has been write-enabled. If you want to print, see the User Guide to enable its write-protection.记忆卡可写功能关闭无法读取
A digital camera or device not supporting the direct printing function is connected to the Camera Port. Disconnect the cable from the Camera Port, and press the RESUME button.此影像装置或记忆卡不支援
监控程式显示:
The selected paper size is not supported by your printer. Fit-to-Page Printing will be selected as Printing Type.所选纸张规格不支援
Paper Source: XX is not available for the selected Media Type. Paper Source setting has been changed to XX.纸张供应来源不支援
No pages are selected for printing. Click the Preview screen and select the pages for printing.未选定要列印之页
The selected Page Size cannot be used in Banner Printing mode.所选列印纸张规格不符
BJ Status Monitor is missing. Reinstall the BJ Printer Driver and try again.监控程式遗失
Selected printer cannot be used. Reinstall the latest BJ Printer Driver and try again.无法侦测印表机
你是要这个吗? em48 |
|
