|
发表于 2007-12-13 19:22:25
|
显示全部楼层
进入维修模式
1 关机
2 按住stop/reset(或许你的为"resume" 我未曾见 故此) 按power 开机
3 power灯亮后 不放power钮 放"stop/reset" 后 立即再按两下
4 待power灯停闪 即可放手=>此为"维修模式" ok
4) When the LED lights in green, press the Stop/Reset button the specified number of time(s) according to the
function listed in the table below.(Each time the Stop/Reset button is pressed, the LED lights alternately in
orange and green, starting with orange.)
=>进入维修后 依照按 stop/reset 钮之次数 再按power钮确认执行 其次数各具不同功能 且依次灯号将 橙绿轮亮 各次数之功能如下:
The number of the Reset
button pressing LED Function Remarks
次数 灯号 作用
0 Green Power off => 取消
1 Orange Service pattern print => 服务讯息列印
2 Green EEPROM print => 列印 EEPROM
3 Orange EEPROM reset=> 重置 EEPROM
4 Green Waste ink counter reset See waste ink counter reset procedures below.=>复归废墨计次
5 Orange Destination setting See Destination setting procedures below.=>我不明此句
6 Green Print head deep cleaning=>喷头深度清洗
11 Orange Button / LCD checking=>按钮或LCD检测
12 或以上 Returns to a menu selection 清除stop/reset 前按之次数 重新选择
这是MP150的 请楼主试试是否通用 请回覆 |
|